
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
POWER MODULE CAPACITOR DISCHARGE PROCEDURE (continued)
FIGURE F.4 – POWER MODULE CAPACITOR TERMINAL DISCHARGE
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
POWER
MODULE
TEST PROCEDURE
1.This procedure must be performed with the engine off.
2.Using the 3/8" wrench, remove the front left and right side panels.
3.Locate the two power modules (one on each side). See Figure F.4.
CAPACITOR
TERMINALS
4.Using the resistor and jumper leads, CARE- FULLY discharge the capacitor terminals.
NEVER USE A SHORTING STRAP FOR THIS PURPOSE. DO NOT TOUCH THE TERMINALS WITH YOUR BARE HANDS. Repeat procedure on the other side.
5.Check the voltage across the capacitor ter- minals. It should be zero volts.