Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
CONTROL TRANSFORMER TEST (continued)
FIGURE F.20 – FRONT CONTROL PANEL REMOVAL
SCREWS 
FRONT
CONTROL
PANEL
SCREW
TEST PROCEDURE
1.This test should be performed with the engine off.
2.Using the 3/8" wrench, remove the four screws holding the front control panel to the case top and sides. See Figure F.20. (There are two screws on the top and one on each side.)
3.Carefully lower the front control panel.
