
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
FIGURE F.50 – STATOR REMOVAL
STATOR / ENGINE
MOUNTING BOLTS &
LOCK WASHERS (8)
BEARING
BOLTS (4)
FAN HUB
FAN NUT
MOUNTING {
PLATE
STATOR REMOVAL PROCEDURE
Return to Section TOC
Return to Master TOC
1.Using the 1/2" wrench, remove the four fan blade mounting bolts and lock washers. See Figure F.50.
2.Using the 1 1/8" wrench, remove the fan nut. Remove the fan, noting its direction for reassembly.
3.Using the gear puller, remove the fan hub.
4.Using the 3/8" wrench, remove the two bolts and flat washers holding the bearing in place.
5.Using the 1/2" wrench, remove the two nuts, lock washers, and carriage bolts holding the generator mounting plate to the machine base.
6.Support the stator with the hoist. Place wooden blocks under the engine to support it when the stator is removed.
7.Using the 9/16" wrench, remove the eight bolts and lock washers holding the stator to the engine.
8.Remove the stator from the engine. It may be necessary to pry and slide it free.