Return to Section TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
FEEDBACK INPUT TEST (continued)
FIGURE F.33. – Plug J2 & J3
Pin 1 | Pin 2 | Pin 6 |
| Pin 2 |
|
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Plug J2
Pin 5
6.If the continuity is not present, check the 67 lead for poor connection. See the Wiring Diagram. Look closely for broken molex pins.
7.Plug J3 back into the control PC board.
8.If all continuity checks in this section are ok but the voltage checks from the previous section are off, replace the control board.
9.Using the Case Cover Removal and Replacement Procedure, install the control panel and side panels on the machine.
Plug J3
Pin 15
Return to Section TOC
Return to Master TOC
