Madrigal Imaging MP-8, MP-9 manual On the MP-9, locate the two

INSTALLATION & SETUP

Step 22 ➤ On the MP-9, tighten the three bolts labeled “D”.

B G R

On the MP-8, tighten the two bolts labeled “D”.

B G R

B G R

Step 23 ➤	A green image is displayed. Loosen the rear wing nut on the
	green lens and slightly defocus the center of the picture.
		B	G R
Step 24 ➤	On the MP-9, locate the two	TOP Bolt
	adjustment bolts at the upper	SIDE
	right corner of the green lens
		Bolt
	mounting plate (viewed from	G
	the front). Adjust the two bolts
	until the top and bottom areas	Before	After
	of the picture are equally defocused. Use the following technique for the
	adjustment: Turn the SIDE bolt 1⁄8 turn CCW. Turn the TOP bolt about 1⁄8
	turn CW until it stops. If defocus at the top and bottom are equalizing,
	repeat until equal. If the top and bottom are not becoming equally defo-
	cused, use the same technique but instead turn the TOP bolt CCW then
	turn the SIDE bolt CW until it stops. Repeat until defocus is equal.
	On the MP-8, adjust the
	large allen head bolt located	B G R
	at the upper right corner of		After
	the green lens mounting plate.	Before

Turn the bolt head until the top and bottom areas of the picture are equally defocused.

NOTE: On all models, it may be necessary to readjust the lens’ rear wing nut to keep the center defocused.

Step 25 ➤ Rotate the green lens using the rear wing nut until the picture is focused in the center. Tighten the rear wing nut.

If necessary, loosen the front wing nut, rotate the front lens

B G R

barrel to readjust the focus in the corners, then re-tighten the wing nut.

2.23