Madrigal Imaging MP-8, MP-9 manual Be cleared by pressing

OPERATION

Channel List ➤ The Channel List utility allows you to display and program the projector’s Channel List. The Channel List is a user-programmable list of sources and projector setups. Sources added to the list can be quickly switched to and displayed by entering their assigned two-digit channel number. Channels may also be selected using the keypad’s up and down arrow keys. Channel selection is described in section 3.3, Source Selection.

To display and/or program the Channel List, press 2 from the Utilities menu. The initial display shows the first ten channels in the list. Up to 99 channels can be displayed. For each channel a name, input number (switcher and slot number), Recall memory number, and up/down list may be programmed.

Program a channel as follows:

When the Channel List is first displayed, the cursor is positioned in the channel number column. While in the channel number column, press or to highlight the channel you want. Alternatively, you can highlight the channel you want by entering the channel number on the keypad. Entering the channel number also allows you to select/display/edit channels beyond the first ten.

Next, press to move the cursor to the Name field. While				.
in the Name column,		and change the character at the		.
				C
cursor position	and	move the position of the cursor. Once
				B
a source name has been entered, move the cursor to the Input				A
field by pressing	ENTER	or by using	. Edit the Input, Recall,	space
and Up/Down (U/D) fields. See below for field definitions.				9
				8
To exit the channel list, press RECALL			or EXIT .
				7

	.
Note: When the cursor is positioned on a edit field, the field may	.
be cleared by pressing .

NOTE: If a channel is selected and ASR is on for the same input, and the incoming frequency does not match the selected setup memories frequency, it may cause the following: ASR may be triggered, the setup memory may change and the channel number may be changed to reflect the new memory.

Example: If Channel 4 shows input (1,3) and no recall number and input (1,3) switcher 1 slot 3 is selected and recall memory 55 is currently selected then the Source Message box will show that Channel 4 is selected unless there is another channel with input (1,3) and recall 55.

3.40