Madrigal Imaging MP-8, MP-9 manual Multi-projector Functions, Projector

OPERATION

3.8Multi-projector Functions

The Projector ➤

In a multi-projector installation it is usually desired to have a single IR key- pad control all the projectors in the system. This section explains the special control functions available for such installations.

The Projector function allows you to select which projector in a group will respond to IR keypad commands. To use this function, each projector in the installation must first be assigned a unique projector number. Projector numbers are assigned through the Communication Setup menu which is

accessed by pressing UTIL 6 2 on a built-in keypad or a wired remote key- pad. Once each projector has its own unique projector number, projectors in the installation can be individually controlled using the same IR keypad.

To select a projector to solely respond to commands from an IR keypad, press PROJ followed by the projector’s identity number. The specified projec- tor will be the only projector which will respond to the keypad. To enable ALL projectors to listen to the IR keypad, press PROJ .

Note: One, two, or three digits may be entered for the projector number. Response is immediate if all three digits are entered (i.e., 001). Otherwise, leading zeros are assumed after a five second time-out. ENTER can also be used when less than the full three digits are entered. For example, PROJ 2 ENTER immediately selects projector 002 for control.

3.51