Madrigal Imaging MP-8, MP-9 manual Preferences entry in Section, Up/Down Channel, Source, Message

OPERATION

The projector switches to, and displays, the source assigned to the channel number. If an invalid switcher or slot number is assigned to the channel, a warning message is displayed.

	Example
	Channel 08 in the Channel List was programmed to select a source connected
	to slot 5 on switcher 3. To select this source, simply press	0 8 .
	Note: If the Channel Select option in the Preferences menu (	UTIL 5 4 ) is set
	to either “1 digit only “ or “1 or 2 Digits”, the preceding zero shown in the
	example above does not have to be entered. For more information, refer to the
	Preferences entry in Section 3.7.
Up/Down Channel ➤	This method of source selection also takes advantage of the Channel List
Selection	feature. It lets you quickly switch between channels programmed in the
	Channel List by using the up and down arrow keys on the keypad.

To make a selection:

Press SOURCE followed by or .

Each time an arrow key is pressed, a channel number (and name) is displayed on the screen. When the channel number you want is displayed, simply wait to allow the projector to switch to the source defined by the channel.

Notes: 1) If a channel specifies a switcher which does not exist, the channel is considered invalid. 2) The Channel List utility allows you to flag the channels to be used by the Up/Down Channel selection feature. For more information, refer to the Channel List entry in section 3.7, Utility Features.

The Source ➤	When SOURCE or RECALL is pressed				Channel Number
Message	at operation level, and/or a				Source Name
		Channel	01
	source switch is made, a source
		IBM PC			Input Number
	message is briefly overlayed on	Input	01
	the projection screen. The	Recall		13	Recall Memory No.
		ASI	S02-R06
	source message displays current				ASI Message
	source information.
	Notes: 1) If screen messages are turned off via the Preferences menu ( UTIL 5 2 ),
	the source message is not displayed. 2) During input selection or Recall memory
	selection (explained later), the message box displays numeric keypad entries as
	they occur. In both cases, two digits must be entered. If only one digit is entered,
	the message box will remain displayed until a second digit is entered or the
	selection is cancelled by pressing EXIT . 3) When an internal source is in use, an
	internal source message is displayed.

3.13