Madrigal Imaging MP-8, MP-9 manual To display the next

INSTALLATION & SETUP

Step 34 ➤ For the MP-9, optical alignment is now complete. If you had removed the foam insert, reinstall it now. Install the front top cover. Proceed to set up each source by following the source setup procedure in section 2.9, Source Setup.

On the MP-8, tighten the bolts labeled “A”. Optical
alignment is now complete. If you had removed the foam
insert, reinstall it now. Install the front top cover. Proceed to
set up each source by following the source setup procedure	B G R
in section 2.9, Source Setup.

2.9Source Setup This section gives step-by-step instructions for quick setup of the projector for a selected external source. For a complete setup, repeat these steps as required for each source connected to the projector.

Before starting, ensure that the projector is optically and mechanically aligned. If optical alignment is required, follow the setup instructions in section 2.8, Optical Alignment. Select the source to be set up using the Source command and make sure it is visible on the projection screen.

	To make setup easier, it is
	recommended that you use
	the projector’s Guided Source
	Setup tutorial. It provides source
	setup instructions on screen to
	guide you through the adjustments.
	To access the tutorial, first press HELP
	at operation level. The Help menu
	is displayed. Next press 1 to select
	Guided Source Setup. The first page
	of the guide will be displayed on the
	projection screen. When using the
	guide,press		HELP	to display the next
	page, press		RECALL	to display the previous page. When complete, press EXIT .
Step 1 ➤	Press BRITE then			or	to increase or decrease the brightness setting until
	black areas in the image just disappear.
Step 2 ➤	Press	CONT then		or	to adjust the contrast of the image to a suitable level.
Step 3 ➤	Press	or	to adjust electrical focus for best overall sharpness.

2.26