Madrigal Imaging MP-8, MP-9 manual ASR Example #2, ASR System Example #2

INSTALLATION & SETUP

Step 6

Press UTIL 1 4 to turn ASR on for the input. Now, each time the computer’s graphics adapter switches operating modes, the projector will automatically adjust its display settings to suit the new mode.

ASR Example #2

Refer to the system illustrated in Figure 2-24 below. Six different sources are connected to a third party (non-Madrigal Imaging) signal switcher. Under normal circumstances, the projector is not aware of source switches made by the switcher. However, if ASR is turned on for the input, and a Recall memory has been set up for each source device, the projector will detect the external source switch and automatically select the appropriate Recall memory. Even if Recall memories have not been set up but ASR is on, ASR will try to adjust the display settings based on the settings of other Input or Recall memories.

	Source "D"	Source "E"
	(setup parameters	(setup parameters
Source "C"	saved in Recall	saved in Recall
(setup parameters	memory 04)	memory 05)
saved in Recall
memory 03)

Source "B"	3rd Party Switcher
	Source "F"
(setup parameters	(setup parameters
saved in Recall	saved in Recall
memory 02)	memory 06)

Source "A"

(setup parameters saved in Recall memory 01)

Figure 2-24.ASR System Example #2

To prepare setup memories for this system, follow these steps:

Step 1

Connect the output of the signal switcher to a projector input. Select the input using the Source command. For this example, press SOURCE 0 1 to select projector slot 1.

2.34