8.5G-50 Connection Set-up

Set the integrated centralized control software TG-2000A, number of G-50A units connected, and the IP address. It is possible for this setting to monitor and display the option functions state of the G-50A.

8.5.1 Setting Procedure and Restrictions

Confirm the precautions and procedure before setting the G-50A connection.

Perform the check before setting the G-50A connection. [Procedure]

1)Select the [G-50 connection set -up] button. Click the [G-50 connection set-up] button located in the system setting group on the initial window.

2)Select the [ON] button after confirming the display contents.

Check the contents of the alarm displayed. When there are not any problems found, click the [OK] button to advance to the setting.

*When the [Cancel] button is clicked, this setting is terminated to return to the initial screen.

Set the G-50A connection in accordance with the

following procedure.

Step 1: Number of G-50 set -upG-50 connection Set-up

Step 2: IP address of G-50 set -up

8.5.2 Number of G-50A se t-up (Step 1)

Set the number of G-50 connected to the system.

S e t-up the number of G-50A [Procedure]

1)Click the “/ “ buttons .

Use the “/ “ buttons to set the number of G-50A. Number of connectable G-50A units: 1 to 40 units

2)Click [OK] button.

When finished making settings, click the [OK] button.

*When the [Cancel] button is clicked, this setting is terminated to return to the initial window.

Number of G-50A set-up

8.5.3 IP address of G-50A se t-up (Step 2)

Set the data of the G-50A IP address connected to the data of the integrated centralized control software.

Register the G-50A IP address. [Procedure]

1)Select the G-50 No. with the “/ “ buttons. In this case, use the “ / “ buttons to select the G-50A No. for which the IP address information is registered.

IP address of G-50A set -up

27

Page 30
Image 30
Mitsubishi Electronics TG-2000A G-50 Connection Set-up, Setting Procedure and Restrictions, Number of G-50A se t-up Step