Mitsubishi Electronics TG-2000A System Requirements Requirements system recommendations, ¡ *1

2. System Requirements

2.1Requirements (system recommendations)

We recommend the following software and hardware when using this application (TG-2000A).

Item	Requirement	Recommended
PC	PC/AT interchangeable machine	Operation check completed, using IBM,
		COMPAQ, and DELL
CPU	Pentium III 350 MHz or faster :	Pentium 4 1 . 8GHz or faster
	within 1000 indoor units
	Pentium III 1 GHz or faster :
	1001 indoor units or over
Memory	128 MB or more	256 MB or more
HDD	6 GB or more (2GB or more of C drive free	4GB or more of C drive free space necessary
	space necessary)
Storage device	FDD, CD-ROM drive	Devices other than those shown at the left may
		a l s o b e i n s t a l l e d .
Resolution	1024 × 768 or higher, 65536 colors or more
Serial port	1 port or more	Required when using RS-485 communication WHM
LAN	Internal LAN (10/100 Mbps)	*1
OS	Windows XP Professional	English version only
	Windows 2000 Professional	* Personal computer must support each OS.
	Service Pack 2 and above

Other

Computer must be dedicated for this use (TG-2000A).

*1 Purchase the option, or use the equipment recommended for the personal computer when purchasing the personal computer.

2.2Compatible Units

The TG-2000A has two main functions: air conditioner controller and cost accounting. However, not all functions are available with all air conditioners.

Table: Compatible units and function list

(¡: supported, ￿: Certain restrictions apply, ×: Not supported)

Function	Control/	Charging (Billing)		Charging (Billing) with WHM
Model	Maintenance	without WHM
Y series	¡		¡ *1
Super Y series	¡		¡ *1
R2 series	¡		¡ *1
WR2 series	¡		¡ *1
WY series	¡		¡ *1
Multi S series	¡		¡ *1
Free plan Indoor unit	¡		¡ *1
Free plan LOSSNAY	¡	×		￿ (A separate watt hour meter is
				required . Billing is done with
				watt-hour units)
LOSSNAY with heating/	¡	×		￿ (A separate watt hour meter is
humidifying				required . Billing is done with
				watt-hour units)
“A” control type	¡	×		￿ (A separate watt hour meter is
	(Adapter required)			required . Billing is done with
				watt-hour units)
“K” control type	¡	×		￿ (A separate watt hour meter is
	(Converter required)			required . Billing is done with
				watt-hour units)

*1 : Can be calculated for each charging block. May not be available with some older models.

2