8.7.6 Set-up of icon arrange and name (Step 5)

Follow these steps to arrange group icons on each floor plane, and enter the group name (LCD name, short name, full name).

Floor Selection

Display

Button

ON/OFF

Set the group icons on each floor and set their names.

 

 

[Procedure]

 

 

1)

Select the floor using the “ / ” button.

 

 

 

In the Group Icon Layout window, use the “ / ” button

 

 

 

to select a floor.

 

 

2)

Select a group.

Group List

 

 

With the floor showing, click the IC group or LC group to

 

 

 

 

 

be assigned.

 

 

3)

Select the location.

 

 

 

Move the mouse pointer to the loc ation where the group is

Group Icon Layout window

 

 

to be assigned, then click that location. When you click this

 

 

location, the group name entry screen will appear.

 

4)Enter the group name.

Enter the LCD, short and full name for the group.

5)Repeat steps 1) to 4).

Layout the groups for each floor and enter their names.

6)Click the [OK] button after finishing with group layout. When finished with group layout and naming, click the [OK] button.

*When the [Cancel] button is clicked, this setting is terminated to return to the initial window.

N o t e :

• The following limitations a pply to group names . * LCD name is a name displayed by G -50A main part. LCD name: Up to 10 characters / Short name: Up to 8 characters / Full name: Up to 20 characters The short names are displayed on the group icons .

Depending on the characters used, the entire 8 characters may not be displayed .

When the [OK] button is clicked without all group icons arranged for the floor, caution is displayed. If so, execute the group placing and nam ing again .

It is possible to use the group name as it is, which i s collected from the G -50A. Note that the setting can only be executed once .

*For the unassigned group, the operation block cannot be set for the following item. Note that the charge calculation is not executed because the setting for the charge(calculation) block cannot be executed. The charge block cannot be set unless the operation block is set. (It is possible to execute the normal operation for entire buildings even if the group is not assigned . )

Deleting, updating and renaming groups and their layout

Follow these steps to delete a group icon, change a group name, or move a group icon. [Procedure]

1)Click the icon.

Click on the previously set group icon. The Delete/Change Name/Move window appears.

2)Click the “Delete”, “Change Name”, or “Move” button.

To delete the group icon, click the Delete button, and the icon is deleted from the floor and returned to the group selection cell.

Icon layout deletion: When the [Delete] button is clicked, the group icon is deleted from the floor display and returned to the group list.

Group name change: Click the [Name change] button, which displays the group name change screen. Change the group name on the screen to the desired name.

Icon movement : Click the [Move] button. Since the icon concerned is set for the selected state, move the mouse pointer to the desired position, and click it. This moves the icon to the desired position.

Note:

Clicking the [ Release] button located in theupper part of the screen makes is possible to release the group icon selected .

When the [Display OFF] button located in the upper part of the screen is clicked, the group list window is not displayed . When the [Display ON] button is clicked, it is displayed.

37

Page 40
Image 40
Mitsubishi Electronics TG-2000A Set-up of icon arrange and name Step, Floor Selection Display Button, Group List