SCSI Device Configuration
Move the cursor onto "SCSI Device Configuration" and press Enter to display the submenu.
The following table lists submenu items, available parameters, and descriptions.
IMPORTANT: Select a parameter for each submenu item on a per- SCSI ID basis. Verify the SCSI ID of a desired device before configuration.
NOTE: To find out the SCSI ID for the optional device connected, select "SCSI Disk Utilities" on the Options menu and press Enter. See "SCSI Disk Utilities" for detail.
Submenu item | Parameter | Description |
|
| |
Sync Transfer Rate | [320] | 33.3 | Select "320". |
|
|
(MB/Sec) | 160 | 20.0 | You may need to change the value | ||
| 80.0 | 10.4 | depending on your optional device. | ||
| 66.6 | ASYN | Refer to the manual that comes with your | ||
| 40.0 |
| optional device for details. |
|
|
Packetized | [Yes] |
| Optimizes bus utilization and minimizes | ||
| No |
| command overhead to bolster performance | ||
|
|
| by transferring commands, data, and status | ||
|
|
| using Deal Transition (DT) data phases. | ||
QAS | [Yes] |
| Quick Arbitration and Selection (QAS) | ||
| No |
| reduces the overhead of control release on | ||
|
|
| the SCSI bus from one device to another to | ||
|
|
| help decrease command overhead and | ||
|
|
| increase bus utilization. |
|
|
Initiate Wide | [Yes] |
| Select "Yes" if your SCSI device supports the | ||
Negotiation | No |
| Wide SCSI interface. Select "No" if not. | ||
Enable Disconnection | [Yes] |
| Select "Yes". |
|
|
| No |
|
|
|
|
Send Start Unit | [Yes] |
| Select "Yes" to send the command to the | ||
Command | No |
| hard disk drive. Otherwise select "No". | ||
BIOS Multiple LUN | Yes |
| Select "No". |
|
|
Support | [No] |
|
|
|
|
Include in BIOS Scan | [Yes] |
| Select "Yes". |
|
|
| No |
|
|
|
|
|
|
| [ | ]: |
|