4-28 Configuring Your Server

Installing the Hard Disk Drives

Install the two or more SCSI hard disk drives to your server. Refer to Chapter 9 for detail.

IMPORTANT: Use two hard disk drives of the same revolution. In addition, use two hard disk drives of the same capacity if you are going to configure RAID1.

Enabling RAID Feature by SCSISelect Utility

The two or more hard disk drives installed can be used either as a single disk or a RAID drive.

To configure a disk drives as RAID drive, you must specify the hard disk drive being connected to the onboard SCSI connector as a RAID drive by using the SCSISelect Utility.

NOTE: The factory-set value is to use the hard disk drive as a single disk drive.

To change settings by SCSISelect Utility:

1.Start the SCSISelect Utility.

AIC-7902 A at Slot 23 02:03:00

AIC-7902 B at Slot 23 02:03:01

2.Select the channel to set HostRAID to open the Options window.

3.Select [Configure/View SCSI Controller Settings] and press Enter.