Troubleshooting 8-25

The following message appears on the screen and the setup is suspended while the Express Setup is executing:

Bad Command or filename

Insufficient disk space

→Follow the procedure described below and check the BIOS settings for the SCSI controller.

As for the procedure on the SCSI controller which is not described in this User's Guide, refer to the manual accompanied with the controller and check the setting for "Int13 Extensions".

<In case the SCSI Controller is AIC-7892>

1.Press Ctrl + A when POST displays "AIC-7892".

2.Select "Configure/View Host Adapter Settings".

3.Select "Advanced Configuration Options" and press Enter.

4.Change the setting of "BIOS Support for Int13 Extensions" to "Enabled".

5.Exit from BIOS setup menu and restart the system.

6.Start the Express Setup.

Setup is interrupted at "Creating a working partition" process during the Express Setup.

Did you connect the hard disk drive that OS is not going to be installed?

→Disconnect the hard disk drive that OS is not going to be installed, and perform the Express Setup.

Problems with Master Control Menu

The master control menu fails to appear:

Is your system Windows NT 4.0 or later, or Windows 95 or later?

→The menu is only able to run on Windows NT 4.0 (or later) or Windows 95 (or later).

Is Shift pressed?

→Setting the CD-ROM with Shift pressed down cancels the Autorun feature. Is the system in the proper state?

→The menu may not appear depending on the system registry setting or the timing to set the CD-ROM. In such a case, start the Explorer and run \MC\1ST.EXE in the CD-ROM.