Troubleshooting
RECOVERY FOR Windows 2000 SYSTEM
If any file necessary for running the OS is damaged, use the following procedures to recover the system.
IMPORTANT:
After recovering the system, see "Updating the System" in Chapter 5 and be sure to update the system.
Also on Windows 2000, you need to update all the drivers after the system update. For more information, see "Installing and Setting Device Drivers" in Chapter 5.
Concerning Windows 2000, see "Installing and Setting Device Drivers" and "Updating the System" in Chapter 5 and be sure to update both the drivers and the system.
If the hard disk drive can not be recognized, you can not recover the system.
Follow the procedure below and use the information in the disk, not system recovery disk, to recover the system.
1.Turn on the system power.
2.Insert the Windows 2000
3.Press Ctrl + Alt + Delete to reset the system.
After a bootable operating system has been installed on the hard disk drive, press Enter while the message "Press any key to boot from CD..." is displayed at the top of the screen.
If no bootable operating system exists on the hard disk drive, this step is unnecessary. The Windows 2000 setup screen will appear.
If the screen is not displayed, Enter was not pressed properly. Begin after turning on the system power again.
4.Press F6 in a few seconds when the window is in either of the following states.
"Setup is inspecting your computer's hardware configuration ..." is displayed.
A screen with a solid blue background is displayed.
IMPORTANT: There is no visible indication on screen when F6 has been pressed.