Maintenance 7-11

RELOCATING/STORING THE SERVER

Follow the procedure below to relocate or store the server:

CAUTION

Observe the following instructions to use the server safely. Failure to follow these instructions may cause a fire, personal injury, or property damage. See pages 1-3 to 1-8 for details.

„Never attempt to lift the server only by yourself.

„Do not install the server in any place other than specified.

„Do not connect/disconnect any interface cable with the power cord of the server plugged to a power source.

IMPORTANT:

„If the server needs to be relocated/stored due to a change in the floor layout to a great extent, contact the service representative.

„Make sure to make a backup copy of your valuable data in the hard disk drive, if any.

„Make sure not to apply a shock to hard disk drives to relocated the server if the contains any.

1.Take a floppy disk and a CD-ROM out of the server, if any.

2.Power off the server (the POWER/SLEEP LED goes off).

3.Unplug the power cord of the server from a power outlet.

4.Remove all the cables from the server.

5.Hold the server by its bottom with at least three persons to carry the server.

IMPORTANT: Do not hold the front door to lift the server. The front door may be disengaged from the server, causing personal injury.

6.Protect the server with the shock-absorbing materials, and pack it securely.