4-44 Configuring Your Server

CONFIGURING MOTHER BOARD JUMPERS

With the pre-installed SETUP utility, you can set desired passwords to protect the data stored in the server against access from unauthorized users. When you forget the passwords, however, you may want clear them. The following describes how to clear these passwords. You can also use the following procedure to clear the CMOS data in the server.

IMPORTANT:

„Clearing the CMOS data resumes the factory-set configuration data.

„After clearing CMOS, you must run the BIOS SETUP utility and execute the following menus to reconfigure your mother board.

–Load Setup Defaults in the Exit menu

–Memory Retest of Memory Configuration in the Advanced menu

–Processor Retest of Processor Settings in the Main menu

To clear passwords or the CMOS data, use the jumper switch on the mother board of the server. The following figure illustrates the jumper switch location.

IMPORTANT: Do not change any other switch settings. Any change may cause the server to fail or malfunction.

: Strapped JBAT1

 

 

Protect

Pin for protecting/

 

 

Clear

 

 

clearing the CMOS contents

1

2

3

 

 

 

 

J7

 

 

 

Protect

 

 

 

Clear

 

 

 

Pin for protecting/

 

 

 

clearing the password