General Description 2-19

PCI Riser Slots

The mother board has two PCI riser slots. Riser slot B provides the following features:

„Bus speed up to 100 MHz

„184 pin, 5 volt keyed, 64-bit expansion slot connector

„Support for a 3-slot PCI riser card

„Support for both full length and low profile PCI cards Riser C provides the following features:

„Bus speed up to 66 MHz

„184 pin, 5 volt keyed, 64-bit expansion slot connector

„Support for a 3-slot PCI riser card

„Support for only low profile PCI cards

Video

The mother board uses an ATI RADEON 7000 PCI graphics accelerator with 8 MB of video SDRAM. The embedded SVGA video subsystem supports:

„Resolutions up to 1600 x 1200 under 2D and 1024 x 768 under 3D

„CRT and LCD monitors up to 100 Hz vertical refresh rate

The mother board supports disabling of the onboard video through the BIOS setup menu or when a plug in video card is installed in any of the PCI slots.

SCSI Controller

The SCSI version of the server board includes an embedded Adaptec AIC-7902 controller providing dual Ultra320 Low Voltage Differential (LVD) SCSI channels.

The SCSI bus is terminated on the server board with active terminators that cannot be disabled. The onboard device must always be at one end of the bus. The device at the other end of the cable must also be terminated. LVD devices generally do not have termination built-in and need to have a termination source provided. Non-LVDs devices generally are terminated through a jumper or resistor pack on the device itself.