9-6 Upgrading Your Server

DEVICE INSTALLATION OR REMOVAL PROCEDURE

Install or remove a component from the server in the following procedure.

Hard Disk Drive

The server has six device bay slots to install hard disk drives with the SCA2 interface (Ultra 320 SCSI) in the disk bay of the front of the server.

IMPORTANT:

„Do not use any hard disk drives that are not authorized by NEC. Installing a third-party hard disk drive may cause a failure of the server as well as the hard disk drive. Purchase hard disk drives of the following models:

<SCSI>

–N8150-163F (73.2 GB, 10,000 rpm, Ultra 320)

–N8150-171F (146 GB, 10,000 rpm, Ultra 320)

–N8150-192 (300 GB, 10,000 rpm, Ultra 320)

–N8150-165F (36.3 GB, 15,000 rpm, Ultra 320)

–N8150-172F (73.2 GB, 15,000 rpm, Ultra 320)

–N8150-193 (146 GB, 15,000 rpm, Ultra 320)

<SAS: when N8154-10 SAS back panel is installed>

–N8150-199 (36.3 GB, 15,000 rpm, SAS)

–N8150-200 (73.2 GB, 15,000 rpm, SAS)

–N8150-201 (146 GB, 15,000 rpm, SAS)

„To make array configuration, specify RAID0, RAID1, or RAID5 as the RAID level.

„Up to six hard disk drives can be installed in standard mode. If using the flex bay, you can install up to seven hard disk drives.