Upgrading Your Server 9-35

8.Install the PCI board on the riser card.

Align the PCI board terminal section with the riser card slot, and firmly push the PCI board until it is fully seated.

 

Slit in the PCI

 

Slit in the PCI

 

board bracket

 

board bracket

Embossed

Embossed

 

 

 

 

 

 

 

 

Top end of the

PCI board bracketGuide rails

Low-profile type

Full-height type

IMPORTANT:

„Do not touch the terminals of the riser cards and PCI boards with your bare hand. Fingerprints and dust left on them cause the server to malfunction.

„If you are unable to install a PCI board correctly, remove it, and then install it again. Be careful not to apply excess force to a PCI board or riser card. Doing so may damage the card.

NOTES:

„Confirm that the slit in the PCI board bracket is positioned by the embossed part. (This applies to other card brackets and extension slot covers.)

„Confirm that the top end of the PCI board bracket is inserted in the designated slot of the riser card.

„If a full-height PCI board is installed, confirm that the PCI board bracket and the edge of the opposite card are inserted in the guide rails of the riser card.