Installing Windows Server 2003 E-11

12.When Windows Server 2003 R2 has been installed, the [Windows setup] screen will be displayed after logged on to the system.

IMPORTANT:

„In this case, the [Windows setup] screen may not be displayed. Be sure to install Microsoft Windows Server 2003 R2 DISC 2 according to the following procedures.

„You can install Microsoft Windows Server 2003 R2 DISC 2 after the application of "System update".

Be sure to install Microsoft Windows Server 2003 R2 DISC 2.

In this case, note that the [Windows setup] screen is not displayed.

13.Insert Microsoft Windows Server 2003 R2 DISC 2 CD-ROM into the CD-ROM drive. Confirm the parameters and click [OK].

14.When the installation has completed, remove Microsoft Windows Server 2003 R2 DISC 2 CD-ROM from the CD-ROM drive, and restart the system.

15.When the installation has completed, be sure to execute the tasks described in "Driver Installation and Advanced Settings" and "Updating the System" of manual.

„SCSI controller (N8103-56)

If your system has a controller (N8103-56), following message often appears on the display during the upgrade installation to Windows Server 2003.

Please type D:/i386 and click OK. (D: CD-Drive) Insert disk

The file 'adpu160m.sys' on Adaptec Windows 2000 Family Manager set V1.12 S2 is needed.

Type the path where the file is located, and then click OK.

„If PROSet is already installed, uninstall the PROSet before upgrading.

If the teaming function is enabled, disable the function before uninstalling PROSet.

„During upgrade installation, [Disk Insert] dialog box may appear. If it appears, click Cancel.

„When upgrade installation is completed, [Device Driver Wizard] dialog box may appear. If it appears, click Cancel, then update the system.