4-38 Configuring Your Server

Creating RAID10 Array

1.Select [RAID-10] on [Select RAID Type] window and press Enter.

2.Use the cursor key to move the focus to the desired hard disk drive and determine it by Space, and then press Enter.

An [X] mark is placed next to the selected hard disk drive.

3.Select the desired stripe size and press Enter. Available stripe sizes are 16, 32, and 64 KB.

4.Enter the desired RAID Name in [Assign RAID Name] window.

IMPORTANT:

„RAID Name must be unique and up to 15 characters are acceptable.

„If a valid partition information or a boot block is detected in the selected hard disk drive, a warning message will be displayed. Select [Yes] to continue creating an array, [No] to terminate.

„Take sufficient care not to select the proper hard disk drive. If not, the data will not be restored.