5-38 Installing the Operating System with Express Setup

6."NOTE" appears. Click [Confirm] after reading that.

NOTE: If some operating system has been installed on the hard disk drive already, the message which asks if you continue the installation appears.

7.If you select "Yes" at step 5, place a floppy disk into the floppy disk drive mounted on the server.

If not, go on the next step.

NOTE: If you set the floppy disk at this step, do not remove the floppy disk from the server until the message as removing the floppy disk appears.

[Using the existing Configuration Disk]

The parameters files in the floppy disk is listed in dialogue-box.

1)Select a parameters file to use in the Express Setup.

After the parameters file is specified, the message "Do you want to review or modify the Setup File parameters?" appears.

2)If you want to modify or confirm the parameters file, click [Review]. If not, click [Skip].

Click [Review] → Go on the next step. Click [Skip] → Go on the step 9.

NOTE: If you do not use disk array controller, go on the step 9. After that, the dialog-box appears.

[Using a blank disk]

1)Click the box under [Setup File Name: (A)] or press A. The dialog box appears.

2)Input the file name and click [Use].