Windows 2000 started with different display resolution from the specified value.
→If the specified display resolution can not be used, the system will use the nearest value or the default value of the driver.
Entered the incorrect Product ID/CD key.
→Even if you entered the incorrect Product ID/CD key, Express Setup will start. However, the setup will stop and asks you to
Unable to specify the details of Network adapter.
→In Express Setup, you can not specify the details of Network adapter. Specify them from Control Panel after starting Windows 2000.
Windows 2000 is started with Network adapter that has not been specified during Express Setup
→Windows 2000 will install the recognized Network adapter specified as default value. If you want to modify the specification, it can be done from Control Panel after starting Windows 2000. Also, the Network adapter that has been specified during Express Setup but that is not connected will not be setup, though the protocol will only be installed.
Connected more than two Network adapter and specified different protocol for each adapter, but all the protocols are specified on either adapter.
→It's a design. Each adapter is specified so that all the installed protocols can be used. The value that can not be specified during Express Setup will all be specified by default value.
When more than two Network adapter are specified, the detailed specification of TCP/IP protocol are all set to use DHCP.
→When more than two Network adapter are specified, the detailed specification of the protocol may all be set by default value.
Not more than two Network adapter is connected, but the detailed specification of the protocol are all set by default.(e.g. Specified IP Address on TCP/IP, but DHCP is specified)
→Are you specifying more than two protocols?
In this case, the situation will be the same as connecting more than two Network adapter, so the detailed specification of the protocol are all set by default.