Installing the Operating System with Express Setup 5-41

12.Copy the modules for the optional mass storage driver.

If you want to install the optional mass storage driver, insert the floppy disk attached to mass storage driver into the floppy disk drive and follow the message to operate the installation.

NOTE: You can use this function only when the floppy disk drive is attached to the system.

13.Remove the NEC EXPRESSBUILDER CD-ROM from the CD-ROM drive according to the message.

If you proceed the setup by using setup parameter file, remove the floppy disk from the floppy disk drive.

Insert Windows 2000 CD-ROM into the CD-ROM drive. [Agree Software License Agreement] screen appears.

14.Read the contents carefully and click [I agree.] or press F8 if you do agree. If you do not agree, click [I disagree] or press F3.

IMPORTANT:

„If you do not agree to this agreement, the setup terminates and Windows 2000 will not be installed.

„If "NetWare Gateway (and Client) Service" is specified to install, the window to specify the details of "NetWare Gateway (and Client) Service" pops up on the first logon. Specify the appropriate value.

15.If you selected [Yes] on [Apply Service Pack] at Basic Information, follow the procedure below.

1)Follow the message to take Windows 2000 CD-ROM out of the CD-ROM drive.

2)Follow the message to insert Windows 2000 Service Pack 4 or later into the CD- ROM drive.

Windows 2000 and the specified application will be installed automatically and logon to the system. Install and configure the device drivers.

Now the Setup using Express Setup has completed.