9-56 Upgrading Your Server

6.Change the jumper (J11) setting as shown in figure below.

J11

: Strap

Standard Redundant

configuration

FRONT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

REAR

Mother board

IMPORTANT: To avoid system malfunction, leave other jumpers at its default position.

If the remote management card is installed in your server, follow these steps to configure the firmware program.

7.Place the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive and reboot the server.

8.Run "Initialize Remote Management Card". Refer to Chapter 6 for details.