9-16 Upgrading Your Server

Server (Pull-out from the Rack)

The server needs to be pulled out from the rack for installing/removing any components other than the hard disk drives and power supply units.

CAUTION

Observe the following instructions to use the server safely. Failure to follow these instructions may result in death or serious personal injury. See pages 1-3 to 1-8 for details.

„Do not install the server on a rack with leaving covers removed.

„Do not pinch your finger with mechanical components.

„Note high temperature.

„Do not pull out a device from the rack if the rack is unstable.

„Do not leave more than one device being pulled out from the rack.

1.See the section "Preparing for Installation and Removal" described earlier to prepare.

2.Unlock the front bezel with the security key and remove the front bezel.

Security lock

3.Loosen the two captive thumbscrews on the front panel.

4.Hold the handles and slowly pull out the server from the rack until it locks.

Captive thumb screws

Handles

When inserting the server back into the rack, push the release levers on the rails on the sides of the server to unlatch the server. Be very careful not to get your finger caught in doing so.