Installing the Operating System with Express Setup
Exceptional Setup
This section explains how to set up the server by the exceptional way. You usually do not have to do as follows. If you want to install the other boards by using a driver floppy disk
Installation of Mass storage device not to be supported by Express Setup
If you want to install the Operating system when the server has new mass storage device not to be supported by NEC EXPRESSBUILDER, follow the steps below.
1.Read the manual supplied with the mass storage device before setting the server.
2.If the mass storage device is disk array controller, configure the RAID system before running the NEC EXPRESSBUILDER.
3.Boot the system from NEC EXPRESSBUILDER
4.(a) When the message "Do you want to use the parameters file..." appears, select "Yes".
(b)When the dialog of Disk array configuration appears, check "Use Existing Array".
(c)Check "Apply
5.Copy the driver for the mass storage device in the Express Setup.
Insert the floppy disk attached the mass storage device into the floppy disk drive. Continue the Express Setup, referring to messages displayed on the display.