Windows Server 2003 x64 Editions Clean Installation
This section explains how to perform a clean installation of Windows Server 2003 x64 Editions.
1.Turn on the system power.
2.Insert the Windows Server 2003 x64 Edition
3.Press Ctrl + Alt + Delete to reset the system.
After a bootable operating system has been installed on the hard disk drive, press Enter while the message "Press any key to boot from CD..." is displayed at the top of the screen.
If no bootable operating system exists on the hard disk drive, this step is unnecessary. The Windows Server 2003 x64 Editions setup screen will appear.
If the screen is not displayed, Enter was not pressed properly. Begin after turning on the system power again.
4.Press F6 while the message "Setup is inspecting your computer's hardware configuration..." is displayed at the upper part of the screen.
IMPORTANT: There is no visible indication on screen when F6 has been pressed.
5.When the following message is displayed, press S.
Setup could not determine the type of one or more mass storage devices installed in your system, or you have chosen to manually specify an adapter. Currently, Setup will load support for the following mass storage devices.
The following message is displayed.
Please insert the disk labeled
into Drive A:
*Press ENTER when ready.
6.Insert the Windows Server 2003 x64 Edition