Oki 24DX manual 127, Fff

40930701TH DRAFT Vesion

127 /

Category	LCD status message		Trouble or status	Remedy
Daily status	READY		Informs that the data within the receiving buffer Overflows.	Press the RECOVER key on the operator panel to release
		ERROR RECEIVE	The operation is continued by pressing Recover switch.	the error display.
		BUFFER OVERFLOW	The host side should be changed in settings to be able to recognize a	Change the setting of the host side so that the host can
	ATTENTION		printer Busy status and the data be re-transmitted.	detect the busy state of the printer.
				Resend the data from the host side to the printer.
	READY		Informs that the printer occurs an Overrun. The operation is continued	Press the RECOVER key on the operator panel to release
		ERROR PRINT	by pressing Recover switch.	the error display.
		OVERRUN	The page formatting should be slightly simplified.	Simplify page data formatting.
	ATTENTION		It can be canceled in PS mode when the completion of a job.
	READY		Informs that an error occurs in serial I/F. The operation is continued by	- Press the RECOVER key on the operator panel to release
		ERROR HOST I/F	pressing Recover switch.	the error display.
		RS232C	This is indicated when parity error, framing error, overrun error and so	- Check the settings of RS232C I/F in the menu.
	ATTENTION		on is detected. The protocol of host and printer should be rechecked.	- Replace the interface cable or the Main board (Board-
				FFF).
				Note: When replacing the Main board, install the
				EEPROM mounted in the replaced Main board.
	READY		Informs that an error occurs in the home position of front tray.	Check front tray home sensor.
		FRONT TRAY ERROR
			Although the front tray becomes unavailable by pressing Recover
	ATTENTION	PRESS RECOVERKEY	switch, the other trays continue operating normally.
			Promotes by indication that a cartridge should be replaced after a 100-	Replace the toner cartridge.
	READY
		TONER EMPTY	sheet printing since the detection of toner low. It is temporarily reset by
	ATTENTION	REPLACE TNR CART	opening and closing the cover. This indication will be displayed each
			20-sheet printing unless the cartridge is replaced.
			Paper of improper size was fed from the tray.	Check the paper in the tray or check to see if more than one
	READY
		ERROR PAPER SIZE	tttttt: MANUAL, TRAY1, TRAY2, FRONT, FEEDER	sheet of copy were fed simultaneously.
	ATTENTION	CHECK tttttt		Open the cover, then close it to perform recovery printing
				and the error display is released.
				If this error occurs frequently, see chapter 6.5.2