Part VII | SD Card (KN2600) |
■COMPOSER LOAD
Load COMPOSER data only from a card.
1.In the RHYTHM GROUP section, press and hold the LOAD (MEMORY) button for a few seconds.
RHYTHM GROUP
POP | ROCK | DANCE POP | BALLAD |
SIMPLE | DANCE | USA | TRAD & |
BEAT | CLUB | WALTZ | |
JAZZ & | BALLROOM | LATIN & |
|
SWING | & SHOW | WORLD | MEMORY |
|
|
| LOAD |
•The display looks similar to the following.
2.Use the buttons below the display to select the
SONG you wish to load.
•Select the folder name first, and then select the SONG name.
•Press the PREV button for the previous page and the NEXT button for the next page.
3.Press the LOAD button.
•Data is loaded to this instrument’s COM- POSER memory (MEMORY).
SD-SOUND LOAD (SMF)
Load
1.On the LOAD (PAGE 1/3) display, press the
•The display looks similar to the following.
•For cards which contain
2.Use the buttons below the display to select the
SONG name you wish to load.
•Use the PLAYLIST button to specify the PLAYLIST (see page 138), the SONG SELECT button to specify the SONG.
•If you press the PLAYLIST EDIT button, the display changes to the PLAYLIST EDIT dis- play. (See page 138.)If you press the TECH button, the display changes to the LOAD dis- play for the TECHNICS SONG.
3.Use the TO SONG button to select the num-
ber to load to (this instrument’s SEQUENCER song number).
•Songs to load are specified one at a time.
•The SEQUENCER song name to load to is shown below the TO SONG button.
4.Use the LOAD AS button to specify the load
method.
•Select from the following. GM/GM2 → GM2:
Activate the GM2 initialized settings, and load GM/GM2 data.
NX → NX:
Active the NX SOUND settings, and load NX data.
GM/GM2 → NX:
Activate the NX SOUND initialized settings, and load GM/GM2 data.
PREV. TEC → NX:
Activate the NX SOUND initialized settings, and load SMF data that was saved in the TECHNICS mode on a previous model. (The volume balance and octave settings may differ from the saved settings.)
•If you select the setting which is different from that in which the song was stored, the sounds, octaves, and arrangement of percussion instrument sounds, etc. will be different.
5.Press the LOAD button.
•The LOAD operation begins.
•When the operation has been successfully completed, “COMPLETED!” is shown on the display.
•If you press the START/STOP button, play- back of the loaded data begins.
•During the LOAD operation, data that cannot be processed by this instrument is ignored.
SD Card (KN2600)
135
