Panasonic SX-KN2400, SX-KN2600 Symptoms which appear to be signs of trouble, Phenomenon Remedy

Symptoms which appear to be signs of trouble

The following changes in performance may occur in the Technics Keyboard but do not indicate trouble.

	Phenomenon	Remedy
	The buttons, keys, etc. malfunction.	• Turn off the POWER button once, then turn it on again.
		If this procedure is not successful, turn off the POWER
		button once. Then, while pressing the three lower left
		buttons in the RHYTHM GROUP section (JAZZ &
		SWING, BALLROOM & SHOW and LATIN &
		WORLD) at the same time, turn the POWER button on
		again. (Note that, in this case, all programmable set-
		tings, functions and memories return to their factory-
		preset status.)
	No sound is produced when the keys are	• The MAIN VOLUME is at the minimum setting. Adjust
effects	pressed.	the volume with the MAIN VOLUME control.
		• The volumes for the selected parts are set to the mini-
		mum levels. Use the balance buttons to set the vol-
		umes of the relevant parts to appropriate levels. (Refer
and		to page 29.)
		• The part is muted. (Refer to page 30.)
Sounds
		• The LOCAL CONTROL for a part performed on the
		keyboard is set to OFF. Set the LOCAL CONTROL to
		ON. (Refer to page 180.)
	Only percussive instrument sounds are produced	• In the SOUND GROUP section, the DRUM KITS but-
	when the keyboard is played.	ton is on.
	The volume is very low when the keyboard is	• The volume setting in the SEQUENCER contents is
	played.	very low. Follow the INITIAL procedure to reset the
		settings. (Refer to page 186.)
	The sound you hear is different from the sound	• This sometimes occurs when you play back
	you selected.	SEQUENCER or COMPOSER data which was cre-
		ated on a different model, or when MIDI data is
		received from a connected instrument. Select the
		desired sounds again.
	The rhythm does not start.	• The DRUMS volume is set to the minimum level. Use
		the balance buttons to set the DRUMS volume to an
Rhythm		appropriate level.
		• A SEQUENCER PLAY button is on. When you are not
		playing back the SEQUENCER performance, turn off
		the SEQUENCER PLAY button.
		• CLOCK is set to MIDI. Set CLOCK to INTERNAL.
		(Refer to page 181.)
AUTO PLAY CHORD	No sound is produced for the automatic accom-	• An ACCOMP part does not sound if its corresponding
	paniment, or only the sounds of some parts are	volume is set to the minimum level. Use the respective
	produced.	balance buttons to set the ACCOMP 1–5volumes to
		appropriate levels.
	Storage is not possible.	• The remaining memory capacity of the SEQUENCER
SEQUENCER		is 0. Follow the SONG CLEAR or TRACK CLEAR pro-
		cedure to erase the memory. (Refer to page 93.)
	The playback measure indication is different from	• The number of measures corresponds to the time sig-
	when the performance was recorded.	nature of the rhythm selected at the start of recording.
		To change the rhythm in the middle of the song, record
		the rhythm change in the RHYTHM part. (Refer to
		page 90.)
		189

QQTG0692