Part IV | Sequencer |
6.During playback, press the PUNCH IN button
at the point you want to begin recording.
•Recording begins as soon as the PUNCH IN button is pressed. Begin playing at this point.
•The REC indication changes to the PUNCH indication.
•The PUNCH IN button switches to the REC STOP button.
7.Press the REC STOP button at the point you
want to stop recording.
•Punch recording stops immediately.
•You can also begin
•You can specify the
6.Press the START/STOP button.
•Playback begins from the measure indicated by CURRENT MEASURE on the display.
•Pertinent information, such as the FIRST MEASURE, is shown in the upper section of the display.
7.Correct the performance.
•The mode changes automatically to the recording mode at the specified FIRST mea- sure. Begin playing at this point. The mode automatically changes back to the playback mode at the specified LAST measure.
•To discontinue punch recording in the middle, press the CANCEL button. In this case, the recorded contents up to that point are erased.
AUTO PUNCH RECORD
You can also set the
1.On the PUNCH RECORD display, press the
AUTO: OFF button.
•The display looks similar to the following.
2.Use the FIRST MEASURE ∧ and ∨ buttons to specify the number of the
3.Use the LAST MEASURE ∧ and ∨ buttons to
specify the number of the
•The number of the LAST measure must be higher than the number of the FIRST mea- sure.
•The specified measure is recorded.
4.Use the COUNT IN MEASURE ∧ and ∨ but- tons to specify the number of
sures you wish to have played back before the
•Set the metronome to on or off with the ON or OFF button.
5.Press the EXIT button.
•The display changes to the PUNCH RECORD display.
85
Sequencer
