Panasonic SX-KN2400, SX-KN2600 manual Velocity Layer, Tone Dynamics, Part, Sound Edit

Part X Sound Edit

VELOCITY LAYER

Adjust these settings to regulate the tone output relative to the velocity.

1.Use the PAGE buttons to view the 3/4 display.

• The display looks similar to the following.

2.Use the buttons to the left of the display to

select a tone (1st, 2nd, 3rd or 4th).

•Use the ▲ and ▼ buttons to select a setting item and then the ∧ and ∨ buttons to specify a selection.

3.Use the L-FADE ∧ and ∨ buttons and the LOW ∧ and ∨ buttons to define the pp sound output area for the lower range.

4.Use the HIGH ∧ and ∨ buttons and the H- FADE ∧ and ∨ buttons to define the ff sound

output area for the higher range.

•By overlapping the L-FADE and H-FADE curves of each different tone, you can change the way the tone sounds relative to how hard or softly the keyboard is played.

5.Repeat steps 2 to 4 for the other tones, as desired.

TONE DYNAMICS

You can adjust the settings so that a different sound (tone) is output for each tone depending on the velocity (how hard the keys are played).

1.Use the PAGE buttons to view the 4/4 display.

• The display looks similar to the following.

2.Use the buttons to the left of the display to select a tone.

3.Use the ▲ and ▼ buttons to select the col- umn for the function you wish to adjust.

4.Select the tone waveform.

•Use the GR ∧ and ∨ buttons to select the sound group. Use the TONE WAVEFORM ∧ and ∨ buttons to select the waveform.

5.Use the LEV ∧ and ∨ buttons to adjust the vol- ume. Use the FLT ∧ and ∨ buttons to set the sound.

6.Use the VELOCITY ∧ and ∨ buttons to specify

the velocity range.

•When the upper limit of a waveform is set to 127, no more waveforms can be added.

7.Repeat steps 3 to 6 to edit the other wave- forms, as desired.

8.Repeat steps 2 to 7 for the other tones, as desired.

Sound Edit

161

QQTG0692