Part II | Playing the rhythm |
Assign a name to the bank/memory
You can assign names to the banks and memo- ries.
1.Select a bank or memory.
2.Use the PAGE buttons to go to the PAGE 2/2 page on the display.
3.Press the BANK NAMING button to assign a
name to the bank, or the MEMORY NAMING button for the memory.
• The display looks similar to the following.
4.Use the buttons below the display to assign a
name.
•Set the character input position with the POSI- TION buttons, select the characters with the alphanumeric buttons and repeat name assignment.
•Switch from upper to lower case letters with the ABC, abc button.
•Press the INS button to enter a space at the cursor position.
•Press the DEL button to erase the character at the cursor position.
•Press the CLR button to erase the entire name.
•Press the →← button to center the name.
5.When you have finished assigning the name, press the OK button.
Recall the panel setup
1.Press the BANK VIEW button to turn it on. Select a bank.
2.Press the desired PANEL MEMORY number
button (1 to 8).
•The panel setup changes to the one stored in the specified memory.
•You can then change the sound settings, etc. manually; however, the contents of the mem- ory remain unchanged until you store them again.
•The “Control Preset” bank of the PERFORM- ANCE PADS or the Foot Switch (sold sepa- rately) can also be used to change from one PANEL MEMORY setup to another. (Refer to pages 64, 172.)
•The currently selected bank, memory number and memory name are shown in the top line on the normal display.
■NEXT BANK
You can press the NEXT BANK button to switch to the next bank. This allows you to change banks without exiting the normal display.
NEXT BANK
•Each time the NEXT BANK button is pressed, the bank indication changes in order (A ➝ B ➝ C ➝ A ➝ B ...).
•The panel settings change when a PANEL MEMORY number button (1 to 8) is pressed.
Playing the rhythm
65
QQTG0692
