E. SNMP MIB Objects

Interface Group – “ifDescr” Object (ifEntry 2)

This object provides information about the interface. Each interface displays a text string as shown below:

Network T1:

Network T1. [Company Name] T1 DSU/CSU, Hardware

 

Version: [CCA number for the CSU board]”.

DTE T1:

DTE T1. [Company Name] T1 DSU/CSU, Hardware

 

Version: [CCA number for the CSU board]”.

COM:

COM port. [Company Name] T1 DSU/CSU, Hardware

 

Version: [CCA number for the CSU board for the standalone,

 

or the CCA number for the DSU board for the carrier]”.

Modem:

MODEM port. [Company Name] T1 DSU/CSU, Hardware

 

Version: [CCA number for the CSU board]”.

AUX:

AUX port. [Company Name] T1 DSU/CSU, Hardware

 

Version: [CCA number for the CSU board]”.

Data Ports:

Data Port n. [Company Name] T1 DSU/CSU, Hardware

 

Version: [CCA number for the DSU board]”

 

(where n is 1 to 4).

Interface Group – “ifType” Object (ifEntry 3)

his object identifies the type of the interface based on the physical/link protocol(s) immediately below the network layer. Only the following values are supported by the DSU/CSU:

Tds1 – Used for the network and DTE Drop/Insert (DSX-1) interfaces.

propPointToPointSerial(22) – Used for the synchronous data ports. Used for the MODEM or COM port when the port is not configured as the SNMP management interface.

ppp(23) – Used for the MODEM, AUX, or COM port when the port is

Tconfigured for PPP.

slip(28) – Used for the MODEM or COM port when the port is configured for SLIP.

Interface Group – “ifMtu” Object (ifEntry 4)

This object identifies the largest datagram that can be sent or received on the interface. It is applicable only to the interface configured as the SNMP management link. This object is zero for all other interfaces.

E-6

February 2001

3160-A2-GB21-90

Page 220
Image 220
Paradyne 3165-A2, 3164-A2, 3160-A3, 3161-B3 Interface Group ifDescr Object ifEntry, Interface Group ifType Object ifEntry