Paradyne 3161-B3, 3165-A2, 3164-A2 manual Initiating a Call for Front Panel Pass-Through Operation

3. Operation

Table 3-6.	Valid Phone Number Characters
Valid
Characters		Meaning	Restrictions
0 to 9		DTMF or pulse digits	—
* #		DTMF digits	—
P		Selects Pulse dialing	Pulse or Tone must be specified,
			otherwise Tone is the default. This must
			be the first character in the string,
			unless the first character is B. Then, it
			must immediately follow the B.
T		Selects Tone (DTMF) dialing	Tone or Pulse must be specified,
			otherwise Tone is the default. This must
			be the first character in the string,
			unless the first character is B. Then, it
			must immediately follow the B.
W		Wait for dial tone	—
B		Blind dialing (you need not wait	To be valid, this must be the first
		for a dial tone before entering	character in the string.
		the dialing sequence)
,		Creates a 2-second pause in	—
		the dialing sequence
<space> ( ) -		Extra characters for readability.	—
		The space is the default
		character.
<-		End Of Number (EON)	—
		character, terminates the dial
		string and erases all characters
		to the right after F3 (Save) is
		pressed

Initiating a Call for Front Panel Pass-Through Operation

Front panel pass-through initiates a call through the integral modem to access a far-end DSU/CSU’s front panel from your DSU/CSU’s front panel (or PC attached to the COM port).

NOTE:

Pass is only available when the FP Pass configuration option has been enabled (see Appendix C, Configuration Options), the active physical interface is either the front panel or the PC, and the integral modem is not already in use.

3160-A2-GB21-90 February 2001 3-57