Paradyne 3160-A3, 3165-A2, 3164-A2 Near End Group dsx1CircuitIdentifier Object dsx1ConfigEntry

Models: 3160-A3 3165-A2 3161-B3 3164-A2

1 298
Download 298 pages 18.84 Kb
Page 230
Image 230

E. SNMP MIB Objects

Near End Group – “dsx1CircuitIdentifier” Object (dsx1ConfigEntry 8)

his object is only supported on the Net T1 Interface.

Near End Group – “dsx1LoopbackConfig” Object (dsx1ConfigEntry 9)

his object specifies the loopback state of the T1 interfaces. Only the following values are supported by the DSU/CSU.

Tdsx1NoLoop(1) – The T1 interface is not in a loopback state.

dsx1PayloadLoop(2) – Specifies that a Payload Loopback (PLB) is active for the network interface or a Repeater Loopback (RLB) is active for the DTE

TDrop/Insert (DSX-1) interface.

dsx1LineLoop(3) – Specifies that a Line Loopback (LLB) is active for the network interface or a DTE Loopback (DLB) is active for the DTE Drop/Insert (DSX-1) interface.

Near End Group – “dsx1LineStatus” Object (dsx1ConfigEntry 10)

his object specifies the line (alarm) status of the T1 interfaces. Only the following values are supported by the DSU/CSU. More than one value may be active at a time.

dsx1NoAlarm(1) – No alarm present.

dsx1RcvFarEndLOF(2) – A yellow alarm signal is being received.

dsx1RcvAIS(8) – An Alarm Indication Signal (AIS) is being received.

dsx1LossOfFrame(32) – An Out Of Frame condition has persisted for more that 2.5 seconds (i.e., Red Alarm).

dsx1LossOfSignal(64) – A Loss of Signal condition has persisted for more that 2.5 seconds (i.e., Red Alarm).

dsx1LoopbackState(128) – The near end of the T1 interface is in a loopback

Tstate.

dsx1Other Failure(4096) – An Excessive Error Rate (EER) has been detected on the network interface.

Near End Group – “dsx1SignalMode” Object (dsx1ConfigEntry 11)

his object specifies whether Robbed Bit Signaling (RBS) is being used. This object differs from the MIB definition in that it is “read-only" (not read/write) for DSU/CSUs. Only the following values are supported by the DSU/CSU.

Tnone(1) – No signaling is being used on this interface.

robbedBit(2) – Robbed Bit Signaling is being used on at least one DS0 on this T1 interface.

E-16

February 2001

3160-A2-GB21-90

Page 230
Image 230
Paradyne 3160-A3, 3165-A2, 3164-A2, 3161-B3 manual Near End Group dsx1CircuitIdentifier Object dsx1ConfigEntry