Philips M3500B manual 3DGV&DEOH2II

		System Messages
Table 12-1 System Messages (Continued)
Message	Description	Corrective Action
1R￿3DGV	The multifunction defib electrode pads	Check the pads cable connection.
	are not properly connected to the Heart-
	Start XLT.
3DGV￿&DEOH￿2II	The pads cable is not connected to the	Check pads connector is locked in place.
	defibrillator.
3DGV￿2II	The pads are not making proper contact	Make sure the pads are properly applied	12
	with the patient.	to the patient.
3DFHU￿)DLOXUH	The pacing system is not functioning.	Remove the device from active use and
		call for service.
3DFHU￿2XWSXW￿/RZ	High patient impedance is resulting in the	Check the pads are applied properly.
	pacer delivering less current to the patient
	than specified in the output current set-
	ting.
6HUYLFH￿8QLW	Appears during a Shift/System Check.	Replace the Data Card.
	May indicate that the Data Card is full.	￿Perform a Shift/System Check
	OR
	There is a system failure.	If 6HUYLFH￿8QLW continues to appear, do
		not use the device and call for service.
6\VWHP￿)DLOXUH￿&\FOH￿3RZHU	An internal error occurred.	If this occurs during actual use:
		Substitute another defib, if possible.
		Remove this unit from clinical use and
		￿call for service.
		If no other defib is available, turn
		power off, then on. If unit turns on
		normally, use for this one incident.
		After this incident, remove from clini-
		￿cal use and call for service.
		If unit does not turn on normally, it
		cannot be used.
		If this occurs during routine testing:
		Remove this unit from clinical use and
		call for service.

M3500B HeartStart XLT Defibrillator/Monitor 12-3