Philips M3500B manual Troubleshooting Tips, Situation Cause Possible Solution

				Troubleshooting Tips
		Troubleshooting Tips
		Table 12-3 lists some situations that you may encounter, causes, and actions to
		take.
Table 12-3 Troubleshooting Tips
Situation		Cause		Possible Solution
The HeartStart XLT	There is no power.			Insert a fully charged battery.
does not turn on.	OR			Attach AC Power cord.	12
	A corrupt Data Card may prevent the unit			Remove the Data Card
	from powering on.			Insert a new Data Card, if available
	OR		￿Turn on the device
	Hardware failure.			Remove this unit from clinical use and
				call for service.
The display is blank	An internal error occurred.		If this occurs during actual use:
except for				Substitute another defib, if possible.
“SYSTEM FAILURE				Remove this unit from clinical use and
CYCLE POWER”.			￿	call for service.
				If no other defib is available, turn
				power off, then on. If unit turns on
				normally, use for this one incident.
				After this incident, remove from clini-
				cal use and call for service.
				If unit does not turn on normally, it
				cannot be used.
			If this occurs during routine testing:
				Remove this unit from clinical use and
				call for service.
The HeartStart XLT	￿The contrast needs adjusting.		￿	Adjust the contrast.
appears to be on but the		The display has overheated.		Avoid exposing the display to direct
display is blank.				sunlight on a hot day.

M3500B HeartStart XLT Defibrillator/Monitor 12-7