Philips M3500B manual Selecting the Lead, Lead Select Choices

NOTE

Selecting the Lead

Selecting the Lead

Available monitoring leads are dependent upon your device configuration:

Table 4-3 Lead Select Choices
Lead Select	If Configured for a:
Choices are:
Pads, Lead I, Lead II, Lead III	3-lead ECG cable
Pads, Lead I, Lead II, Lead III, aVR,	5-lead ECG cable
aVL, aVF, V lead.

To select a lead to monitor, cycle through the choices by pressing					/($'	until
the desired lead is displayed.					6(/(&7
When V lead is selected, change to a different V lead by moving the electrode
to a new location rather than by pressing the			/($'	softkey.
			6(/(&7
Figure 4-3 ECG Monitoring Display
HR ALARM		LEAD
		SELECT
	78	Lead II					4

Monitoring Rhythm

	Shocks: 3
	00:00:49
PAUSE	ANALYZE

If the desired lead is not connected or the electrodes are not making proper contact with the patient, the message /HDGV￿2II is displayed in the System Mes-

sage Area and accompanied by a beep to alert you. A dashed line on the dis- play indicates that there is no ECG signal.

M3500B HeartStart XLT Defibrillator/Monitor 4-5