Chapter 2 - Hardware Installation

Connecting to the power source

You can connect to an AC Inlet power supply at your site. It is important to follow these steps.

The following restrictions apply to the conductors and connectors that may be used to ground the unit when rack mounted:

When using bare conductors, they must be coated with an appropriate antioxidant compound before crimp connections are made. Tinned, solder-plated or silver-plated connectors do not have to be prepared in this manner.

The same bolt assemblies should not secure multiple connectors.

Listed fastening hardware must be compatible with the materials being joined and must be preclude loosening, deterioration and electrochemical corrosion of the hardware and joint materials.

To connect to the AC Inlet:

1.Make sure the power switch is OFF. Insert the power cable into the power connector on the rear panel of the MGC+100 unit.

Main Switch

AC Inlet

2.Insert the power cable into the power source socket.

3.Turn on the power by pressing on the power switch located on the rear panel of the MGC+100 unit.

2-18

Page 38
Image 38
Polycom DOC2238A manual To connect to the AC Inlet, Connecting to the power source