Chapter 2 - Hardware Installation
Connecting and Setting Up the MGC+50
Use the MGC+50 rear panel diagram below for reference.
DEBUG
LINE IN
LAN |
VGA
MOUSE 
KEYBOARD
COM1
COM2
ALARMS
COM2
COM1
KEYBOARD 
MOUSE 
VGA
LAN
Figure 2-14: MGC+50 Rear Panel with External Connectors
To connect the MGC+50 to the network and power source and set up the system the following procedures are performed:
•Connecting the MGC+ unit to the power source (AC inlet)
•Connecting the MGC+ unit to the LAN Network (C.B., I/O)
•Connecting the MGC+ unit to the Operator Workstation (PC) directly via COM2 (optional)
•Connecting the MGC+ unit to the network(s)
MGC+50 Dongle
MGC+50 is shipped with a serial dongle and is installed on COM1 of the Control unit’s rear I/O panel. A special bracket ensures that the dongle remains in its fixed position. The dongle is required for normal operation of the MCU. If the dongle is missing, please contact support.
