Promise Technology M500p, M500i, M500f, M300p, M300i Enclosure, Event Log, Host Interface Controller

VTrak M-Class Product Manual

Event	Action
Drive-interface controller	Restart the VTrak. See page 218. If this message
is NOT found	appears repeatedly, contact Technical Support. See
	page 299.
Drive-interface	Normal.
diagnostics has passed
Drive-interface	Restart the VTrak. See page 218. If this message
diagnostics has failed	appears repeatedly, contact Technical Support. See
	page 299.
Drive-interface controller	Drive-to-controller parity error. If this message
has generated a general/	appears repeatedly, contact Technical Support. See
data parity error.	page 299.
Enclosure
Enclosure temperature is	The VTrak is overheating. Check for airflow around
above the threshold/	and through the VTrak, and verify that all fans are
warning threshold	working. Replace fans as needed.
Enclosure temperature is	The VTrak is seriously overheating. Check for airflow
above the critical	around and through the VTrak, and verify that all fans
threshold	are working. Replace fans as needed.
Enclosure temperature is	Normal.
within the normal range
Event Log
Event logging is enabled	Event logging has been successfully enabled.
Event logging is disabled	Event logging has been disabled.
Event log buffer is cleared	The event log was cleared.
in RAM
Event log buffer is cleared	The non-volatile RAM event log was cleared.
in NVRAM
Event log buffer is cleared	The MDD (disk drive) event log was cleared.
in MDD
Host Interface Controller
Host-interface controller	A FC/iSCSI error occurred. If this message appears
has detected parity/data	repeatedly, contact Technical Support. See
parity/command parity	page 299.
error

274