A – Command Line Interface | 0 | |
|
| |
Image Command |
|
|
|
|
|
|
|
|
Image Command
Manages and installs switch firmware.
Authority | Admin session | |
Syntax | image | |
|
| cleanup |
|
| fetch [account_name] [ip_address] [file_source] [file_destination] |
|
| install |
|
| list |
|
| unpack [file] |
Keywords | cleanup | |
| Removes all firmware image files from the switch. All firmware image files are | |
| removed automatically each time the switch is reset. | |
| fetch [account_name] [ip_address] [file_source] [file_destination] | |
| Retrieves image file given by [file_source] and stores it on the switch with the file | |
| name given by [file_destination]. The image file is retrieved from the FTP server | |
| with the IP address given by [ip_address] and an account name given by | |
| [account_name]. If an account name needs a password to access the FTP server, | |
| the system will prompt you for it. | |
| install | |
| Downloads firmware from a remote host to the switch, installs the firmware, then | |
| resets the switch (without a | |
| possible, a | |
| the following: | |
| | IP address of the remote host |
| | An account name and password on the remote host |
| | Pathname for the firmware image file |
list
Displays the list of image files that reside on the switch.
unpack [file]
Installs the firmware file given by [file]. After unpacking the file, a message appears confirming successful unpacking. The switch must be reset for the new firmware to take effect.
