0

3 – Managing Fabrics

 

 

Managing the Fabric Database

 

 

 

 

5.Configure the port types for the new switch using the Port Properties dialog. The ports can be G_Port, GL_Port, F_Port, FL_Port, or Donor.

6.Connect the devices to the switch.

7.Make any necessary zoning changes using the Edit Zoning dialog. To open the Edit Zoning dialog, open the Zoning menu, and select Edit Zoning. If you changed the Default Visibility setting in the Zoning Config dialog from All to None, change that setting back to All. To open the Zoning Config dialog, open the Zoning menu, and select Edit Zoning Config.

3.4.7

Replacing a Failed Switch

The archive/restore works for all switches. However, the Restore menu item is not available for the in-band switches. You can only restore a switch out-of-band (the fabric management switch). There are certain parameters that are not archived, and these are not restored by SANsurfer Switch Manager. Refer to ”Archiving a Switch” on page 4-35and ”Restoring a Switch” on page 4-36for information about archive and restore. Use the following procedure to replace a failed switch for which an archive is available.

1.At the failed switch:

a.Turn off the power and disconnect the AC cords.

b.Note port locations and remove the interconnection cables and SFPs.

c.Remove the failed switch.

2.At the replacement switch:

a.Mount the switch in the location where the failed switch was removed.

b.Install the SFPs using the same ports as were used on the failed switch.

CAUTION! Do not reconnect inter-switch links, target devices, and initiator devices at this time. Doing so could invalidate the fabric zoning configuration.

c.Attach the AC cords and power up the switch.

3.Select the failed switch in the topology display. Open the Switch menu and select Delete.

59022-11 A

3-25

Page 75
Image 75
Q-Logic 59022-11 A 4-13, SANBOX2-16 manual Replacing a Failed Switch