A – Command Line Interface | 0 | ||||
|
|
| |||
Set Config Command |
|
|
| ||
|
|
|
|
|
|
|
|
| Table | ||
|
|
| |||
|
|
|
|
| |
| Parameter |
| Description |
| |
|
|
|
|
| |
| LCFEnable |
| Link control frame preference routing. This parameter |
| |
|
|
|
| appears only if AutoPerfTuning is False. Enables (True) or |
|
|
|
|
| disables (False) preferred routing of frames with R_CTL = |
|
|
|
|
| 1100 (Class 2 responses). The default is False. Enabling |
|
|
|
|
| LCFEnable will disable MFSEnable. |
|
| MFSEnable |
|
| ||
|
|
|
| only if AutoPerfTuning is False. Prevents (True) or allows |
|
|
|
|
| (False) the interleaving of frames in a sequence. The default |
|
|
|
|
| is True. Enabling MFSEnable disables LCFEnable and |
|
|
|
|
| VIEnable. |
|
| VIEnable |
| Virtual Interface (VI) preference routing. This parameter |
| |
|
|
|
| appears only if AutoPerfTuning is False. Enables (True) or |
|
|
|
|
| disables (False) VI preference routing. The default is False. |
|
|
|
|
| Enabling VIEnable will disable MFSEnable. |
|
| MSEnable |
| Management server enable. Enables (True) or disables |
| |
|
|
|
| (False) management server on this port. The default is True. |
|
| NoClose |
| Loop circuit closure prevention. Enables (True) or disables |
| |
|
|
|
| (False) the loop’s ability to remain in the open state |
|
|
|
|
| indefinitely. True reduces the amount of arbitration on a loop |
|
|
|
|
| when there is only one device on the loop. The default is |
|
|
|
|
| False. |
|
| IOStreamGuard |
| I/O Stream Guard. Enables or disables the suppression of |
| |
|
|
|
| RSCN messages. IOStreamGuard can have the following |
|
|
|
|
| values: |
|
|
|
|
| Enable – Suppresses the reception of RSCN messages |
|
|
|
|
| from other ports for which IOStreamGuard is enabled. |
|
|
|
|
| Disable – Allows free transmission and reception of |
|
|
|
|
| RSCN messages. |
|
|
|
|
| Auto – Suppresses the reception of RSCN messages |
|
|
|
|
| when the port is connected to an initiator device with a |
|
|
|
|
| QLogic HBA. For older QLogic HBAs, such as the |
|
|
|
|
| QLA2200, the DeviceScanEnabled parameter must also |
|
|
|
|
| be enabled. The default is Auto. |
|
| PDISCPingEnable |
| Enables (True) or disables (False) the transmission of ping |
| |
|
|
|
| messages from the switch to all devices on a loop port. The |
|
|
|
|
| default is True. |
|
|
|
|
|
|
|
security
Initiates an editing session in which to change the security settings. The system displays each parameter one line at a time and prompts you for a value. For each
