Q-Logic 59022-11 A 4-13 manual Pagebreak state, Port option, Setup option, Switch state, Timezone

0		A – Command Line Interface
		Set Command
	pagebreak [state]
	Specifies how much information is displayed on the screen at a time according to
	the value given by [state]. This keyword does not require an admin session. [state]
	can be one of the following:
	on
	Limits the display of information to 20 lines at a time. The page break
	functions affects the following commands: Alias (List, Members), Show
	(Alarm, Log), Zone (List, Members), Zoneset (List, Zones), Zoning (Active,
	List).
	off
	Allows continuous display of information without a break.
	port [option]
	Sets port state and speed for the specified port. The previous Set Config Port
	settings are restored after a switch reset or a reactivation of a switch
	configuration. Refer to the ”Set Port Command” on page A-75.
	setup [option]
	Changes SNMP and system configuration settings. Refer to the ”Set Setup
	Command” on page A-77.
	switch [state]
	Changes the administrative state for all ports on the switch to the state given by
	[state]. The previous Set Config Switch settings are restored after a switch reset
	or a reactivation of a switch configuration. [state] can be one of the following:
	online
	Places all ports online
	offline
	Places all ports offline.
	diagnostics
	Prepares all ports for testing.
	timezone
	Specifies the time zone for the switch and the workstation. The default is Universal
	Time (UTC) also known as Greenwich Mean Time (GMT). This keyword prompts
	you to choose a region, then a subregion to specify the time zone.
Examples The following examples enables and disables the beacon:
	SANbox2 #> set beacon on
	Command succeeded.
	SANbox2 $> set beacon off
	Command succeeded.

59022-11 A A-59